567. Trimming/Assembling Spout and Handle Rings for a Bamboo Overhang Teapot with Hsin-Chuen Lin 林新春

Hsinchuen Lin
205 followers
1 Video View·Feb 8, 2021
To see or buy my finished work and pottery tools, please visit my ETSY shop:
http://www.etsy.com/shop/hsinchuen
http://www.etsy.com/shop/hsinceramics
http://www.etsy.com/shop/hsintools
http://www.etsy.com/shop/potterysquare
To watch more of my throwing videos, please visit my channel:
http://www.youtube.com/user/hsinchuen/videos
To learn more about my back ground, please visit my Website:
www.mypots.net
Follow me on Instagram: hsinchuenlin
Like me on Facebook page: Hsin-Chuen Lin Ceramics
Right, so two days ago I threw several parts for the teapot with the sodium silicate texture.
So today I'm ready to trim and try to assemble.
And the whole process usually takes me about an hour to do that. So I will speed up by
using the time-lapse mode so you don't need to spend a whole lot of time to watch that.
And before I started, this is my procedure usually when I'm making the teapot. So I will trim the
body first. And usually my teapot lid is a little bit bigger than the actual size.
So after I trim the bottom, I turn it upside down and then trim the room here so that the lid is
nice and sitting on top of it. And then I will try to let my lid sit on the body and then trim the
knob so that I can look at the whole proportion. And then after that I will try to shave the clay
off so that the spout is fitting much more better and then assemble. And I will do the
bamboo handle. This kind of teapot, this is very wide. So if you have a handle here,
the whole piece looks stretched. So this kind of shape, I usually like to have the handle on top.
So the bamboo handle. So I will start to trim the body first.
narrow, tight. And then I am using a shiny stone to just compress it.
So that after I compressed it, the whole piece is fitting very tight.
So when I'm trimming the knob, the piece is not movable. So I tried to make it very tight. So
just by using a shiny rock to compress it. So the whole piece is very tight now.
Now I'm ready to try to assemble the spout and also the handle.
Right, so before I try to assemble the spout, I like to prepare my handle first.
Because the handle needs time to dry. It's going to be a bamboo handle. So I will
roll the coil for hanging the bamboo. Put in a bit of a texture on the handle.
To prevent the handle from when you bend it,
to prevent it from cracking, you might want to use the fresh clay.
Give myself an idea roughly where is the location of the handle and then the spout here.
Right, so I will put my overhang handle aside to let it dry while I'm trimming this spout.
I usually like to put my kipa a little bit higher on the wheel. So I put my hand wheel here.
So it's easy for me to spin around. Like I told you, before the whole spout gets dry,
when it's still soft enough, but without a lot of water, I go back here and then
pinch it a little bit. So this part is a bit thinner.
So after I fire, I can put the handle over it. For the joint here,
I will wait a little bit drier and then I'm going to put a tiny coil to patch it here.
So this part gets all the weight from these two handles, little handles. So you want to do a good
job on reinforcing the joint. But now it's still a bit wet, so I will wait a little bit
drier and then just patch it with the coil.
All right, so this is the teapot. Hope it helps. See you next time.
