36 | Cách Vẽ Rập Cổ Áo Sơmi Mẫu 1 | PHÁT TRIỂN MẪU VIỆT HIÊN

Welcome all of you to the Viet Hieu Model Development channel Today I will show you how to make the high-quality Minam shirt pattern After you have designed the front and back of the shirt Then you will remeasure the finished neck measurement of the front bodice and add it to the finished neck measurement of the back bodice and I will start cutting the pattern Exactly according to the measured specifications or you can make a copy of that dress it is longer than the measurement I just took And I made the pattern for it so that next time I can use the same pattern with different measurements My job next time is just to adjust the length of the pattern The collar and the front of the neck should fit well with the neck opening of the shirt Then I will try the front neck area and the deep neck of the shirt I just measured is 42cm and now I will move on to the design par First you will check the straight line like this Next you will check the horizontal straight line as follows I set this point as point A then from point A I will take up the measurement of the deep neck circumference plus the front neck circumference divided by 2 en my neck size is 42cm the deep neck and front neck are 42cm en I divide by 2 to get 21 cm then I take this space which is 21 cm Then I will draw a vertical line like this I set this point as point B from this point A I take up the wide part of the neck the wide part of the neck is 3.2 cm en I will take it as 3.5 cm On this side as well I took it as 3.5 cm Then this straight line This straight line AB will be divided into three equal parts Next I will connect the two points I will use this vertical line to measure the ankle circumference From point B I will measure up 1 cm and from point A you take up 0.3 cm which is 3 mm Now I will connect the two points Then I will bend it to match this diagonal straight line which is about 0 3mm and you will bend it again like this At this point I will rise again by about 2mm and when I reach point A I will make it perpendicular Then this corner will be a right angle Then you place the ruler in this corner and you will draw a diagonal line Make sure this corner is a right angle Next the straight line on top will be divided into two parts and I will clean the back of the neck here it starts from this position and this part you will round it off perfectly I measure again at this point and this section is perfectly round like this Next from this point I will take up 1.2 cm and on this side I will also take up 1.2 cm Then I connected the two points of access and we will go down this road to take the leaf of the collar Next from this point I take up 4.7 cm and from this point you also take up 4.7 cm Then I connected the two points of access en from this side you will take 1.6 cm Then I will place the ruler at the 1.6 cm mark so that the edge of the ruler aligns perfectly with the slanted edge And I take it from this position en from this position I will take it as 0.3 cm it will be the gap between the two leaves of the valve When I wear it I button the button on the collar and from this point I will draw a perpendicular line From the edge where I just broke I will measure up 1.5 cm and then I connected the two points of access and from this point I will take it as 7cm Then this straight line will be divided into three equal parts And I will curve the top edge of the collar like this I will press it again like this when I reach this point I will press it again like this Next the bottom part will be divided into two equal parts And I will bend the bottom edge of the collar starting from this point to this point I will then bend it out a bit I will bend it until the edge of the collar This is the folded position Thank you all for watching my video if you found my video useful Then like share and comment Thank you all