3. CÁCH VẬN HÀNH CHÂN GIÁ ĐÀI.

When you receive a price, investors first care about how to operate it. I will explain. Investors who are familiar with the price-to-image operation are very simple. No need to care about this clip. But most of our investors are not familiar with the price-to-image operation. To operate the price-to-image operation, first, we have to make this leg spread out. Make a hole in the middle of the leg and spread it out. When the leg is spread out, we have to tighten it again. Next, we have to open these loops and pull the three legs out. And lock the loop. And when you take the leg back, don't forget to lock these three legs. All the legs have hooks to hang in the opposite direction. You can use a brick, a half brick, or a bag to hang it here. If you hang a bag, it will be better than a brick. But you can hang anything as long as it is heavy enough to resist the wind. If the wind is strong, we need to use this method. If the wind is light and there is no wind, we don't need to care about this technique. After locking the three legs, if we still need to increase the height, we have to loosen this part and tighten this part. Remember to loosen this part because if we don't loosen it, it will be easily scratched and this part will be broken. When we tighten it to the required height, we tighten this part again. Then we tie this leg to make it easier to operate. I usually put some rubber in this box to increase the height of the legs so that the box does not affect the sound quality. If we don't need it, we can throw it away. However, I advise you to put this rubber to improve the sound quality. There is also a saying that I should make a machine to cover the table, but it is very complicated and difficult to operate. I think the simplest way is to use a plastic bag to cover the table to ensure the safety of the table when it rains and does not affect the sound of the table. So, operating a table leg is very simple without tools. Even without this clip, I think a lot of beginners will be able to use it. But I think with this clip, the beginners will be less clumsy. It only takes a few operations to get used to it and remember it right away. I hope you will use this machine effectively and successfully. I wish you all the best.