Here is how to Change Transmission Fluid on 2019 Toyota camry Cars without Transmission dipstick

Hello it's Salim here. In today's video we're gonna be replacing transmission fluid on this 2019 4-cylinder Toyota Camry. These newer models of Toyota Camry not coming with transmission dipstick so you cannot check the level only if you change the fluid. So in this video I will show you where to drain the old fluid and where to fill the new fluid and how to make sure that you didn't overfill the new fluid. So for the fluid type we're gonna need Toyota's WS fluid type. If you So for doing this job we're gonna need three and a half liters of this four liter can. Approximately two and a half liters will come out from the drain pan. We're gonna fill it with three and a half liter of new fluid and flush the rest which it will determine the right level in the transmission pan which I will show you in a minute. We're also gonna need gloves, one meter of hose, and a funnel like this. You can use a DC pump like this as well which makes the job much easier and much faster for filling new fluid but I'm gonna stay with the funnel to lower the cost for you guys. You should know filling plug located behind the driver's side wheel. You can just turn the wheel to the left and do the work but I'm gonna remove the wheel and show you how it looks with better angles. So I'm gonna lock the rear wheels, loosen the lug nuts while the wheel on the ground and then jack up the car and put it on a jack stand and remove the wheel. You don't need to have all these tools I'm just doing that to show you better angles with the camera. So the wheel been removed and placed under the car for extra safety. Here's where the filling plug located. We also gonna need a ratchet and 10 millimeter socket. There is also a plastic tab missing so don't forget to remove that as well and the cover comes off just like this. And here's the filling plug which labeled as WS and it's 24 millimeter size. All right let's go under the car and locate the drain plug. Here is the drain plug and it's 10 millimeter hex. Drain pan is ready let's take the 10 millimeter hex and remove the plug. Keep that in mind only with removing drain bolt all the fluid from the drain pan won't drain. There is a plastic straw inside it that determine the right level after filling up the new fluid so you have to remove that as well. So we gonna need a 6 millimeter hex and you can remove it by hand. With the straw been removed now we can let it drain for few minutes. All right the pan is empty let's put the straw back and make sure to only hand tight it you don't have to over tighten it. A quick wipe and then putting the drain bolt back on and I only hand tight it as well because after filling we have to drain the overflow fluid with a warm and running engine. Next we gonna need a 24 millimeter socket to remove the filling bolt and here is also labeled WS fluid type only. All right let's open the can and I also attached the hose and the funnel as well. Let's put three and a half liters of new fluid in the transmission. If you working alone like me clamp the funnel like this so the fluid won't spill on the car accidentally and I also placed a sharp towel under the funnel in case of any oil drip. Take a half liter before pouring the fluid so you know that only three and a half liter in the can. Okay I just put three and a half liters of new fluid let's remove the hose and put the filling bolt back and then tighten it again. A quick cleaning so it doesn't accumulate dust. Now we can put the cover back on and I also adding the missing plastic tab as well. All right now we can put the wheel back on the car, jack up the car, remove the jack stands and lower the car. Now we can torque the lug nuts to the factory spec. Now you can start the engine and let it warm up. You can shift the gears as well it should be soft shifting. Let's not forget the oil in the transmission not at the right level but it's a bit more than the right level so take the car out for a test drive just warm up the gears but avoid aggressive acceleration. All right we are back the transmission is warmed up and the car at the flat level. Now we can open the drain plug and drain the overflow oil and it will be at the factory level. Keep that in mind only overflow oil will be drained because of the plastic straw. Draining is done now we're gonna put the drain bolt back on and tighten it back. Cleaning drain bolt is important in case of leaking oil. And now we are done with changing transmission oil. You must have softer gear shifting after oil change. You should do this oil change every 30,000 to 50,000 miles. And here is how to replace transmission fluid on 2019 Toyota Camry without using pump or any expensive tool. That's it for this video hope the video was helpful and learned something new. If it was like and subscribe if you haven't already and I will see you in the next one. Bye for now!