New Ender 3 v2 Profile for cura 4.11

Welcome to the channel! today were going to give you my UPDATED Perfect Profile for the ender 3 v2 in cura. im using Cura 4.11 but the profile is backwards compatible, and shows virtually no layer lines at .16mm layer height. we will go over a few of the settings, and what adjustments you can make in cura without adversely effecting print quality!

Here it is, my updated perfect profile for the ender 3 v2! let me know how it works out for you, i havnt had any issues importing or using this version, also, leave a like and subscribe!


get the profile here:
https://github.com/Vanethrane/Cura-Profiles/blob/master/ender3v2-2021-cura411.curaprofile

Like and Subscribe!

Send me a gwei! (ether address, all donations accepted!)
0x95F4EaB8A738F4F27e7c04aEe1E10C8E666C2D0c
send me a satoshi! (bitcoin address, all donations accepted!)
31zvj8ybxVVTLw6nPvAHYqu3qDVhC1sRqk

Find 3dprinters and other cool Tech at:
https://www.amazon.com/shop/technivorous3dprinting?ref=cm_sw_tw_r_inf_own_technivorous3dprinting_dp_6kKLbH7OEOFJy

SUPPORT TECHNIVOROUS 3D Printing:

TeeSpring Technivorous Merch!
https://teespring.com/stores/technivorous-merch-preview-run
become a channel member for youtube perks!
https://www.youtube.com/channel/UCuMbDfVJqY4XnWbTUmH3AmQ/join
Paypal: [email protected]
Check out my Patreon page: https://www.patreon.com/Technivorous
or you can buy me a coffee: https://www.buymeacoffee.com/technivo...

Current Channel Goal: 50,000 Subs!