Hidden hinges using the Festool Domino DF500

Newman Specials Woodwork
1 follower
Nov 17, 2026
I posted a similar video to this previously and the finished product was not great. This is how it actually looks versus the quick video job I did before.
The key is knowing the dimensions of the hinge and using the correct bit and measurements to get this to come out right. I used the 10 mm bit for the 13 mm wide piece
Hidden hinges are a huge help in many projects.
I like to use these sauce hinges and my Festool
Domino to install them. This is my technique.
It's not necessarily the right one. It's one of many,
but it's how I do it. First thing I do, obviously,
is mark off spots on the pieces I want to install
This is to line up the domino
and make sure that the holes are in the same
place. The hinge thickness is actually 13 millimeters
so I'm using the Festool Domino 10 millimeter bit.
For each hinge I need to make a series of cuts twice.
The first series of cuts are set to a three-quarter inch wood thickness
and I also set the domino depth to 20 millimeters
because the hinge is 18 millimeters deep.
At this point I'm only making holes that
are wide enough for the deepest part of the hinge.
As you can see, the hinge part would fit within that hole,
but it is not wide enough.
...and deep enough, so I need to go back and cut again.
I'm going to use this piece that I created
out of PEX. It has a groove in the back
that fits over the depth slide on the Festool Domino.
This will make sure that I don't go too deep
for the wings of the hinge.
In order to cut this groove,
I actually set up the top measuring piece 18 millimeters
from the center part that I originally measured,
and I cut each of my side wings.
You can see how this gives the deeper center part
and two shallow wings.
I did this again on both sides
and then I had to change the height of the cut.
I now move down to 7 8 of an inch
and put this little piece in there because it's about a
millimeter. The hinge itself is 13 millimeters across.
The bit is only 10. I added three
millimeters down. This matches the width
of the hinge that I'm going to be putting in there.
I repeated it on all sides and then I have to take out my spacer
so that I can go full depth.
Because it's a simple clip-on,
I just pushed it down and dropped it back out.
Now I'm able to do the center hole again
at the correct depth to match the piece.
Obviously I repeated this for all four pieces
so that I had matching sides.
You can see my test fit here with the two pieces.
I didn't actually screw it in place
at this point because I still want to finish up everything
but the pieces went together
very nicely. Everything fits together well.
After I was done with the piece I finished up
the two top halves and then I went ahead
and installed the hinges where they were supposed
to be. I pre-drilled all the holes
and then inserted screws into it to hold it into place.
I used a self-centering drill bit to make sure
that everything was centered up so it would stay
lined up and I used number six screws
at three quarter inch length to hold them into place.
Once the screws were in place I was able
to lay it flat and check the seam.
Here you can see the final product in place
and you'll notice you can't even see the hinges.
When it's opened they look really good.
