412. Trimming/Assembling a Side Handled Teapot with Hsin-Chuen Lin 林新春 側把壺修坯接坯示範

Hsinchuen Lin
205 followers
20 Video Views·Apr 12, 2020
To see or buy my finished work and pottery tools, please visit my ETSY shop:
http://www.etsy.com/shop/potterysquare
http://www.etsy.com/shop/hsintools
http://www.etsy.com/shop/hsinchuen
To watch more of my throwing videos, please visit my channel:
http://www.youtube.com/user/hsinchuen/videos
To learn more about my back ground, please visit my Website:
www.mypots.net
Follow me on Instagram: hsinchuenlin
Like me on Facebook page: Hsin-Chuen Lin Ceramics
Okay, today I'd like to show you how I finish
Trim and assemble a teapot
That I made two days ago
It's gonna be the side handle teapot. So this is the handle I
drew
two days ago and then
fit in the spout
for a teapot
The tool I will use of course, it will be the my regular trimming tool the number two
Trimming tool. This is tungsten carbide
I've been use for
couple months without resharpening it
Also, I will use my number three also the carbide tool you can use a stainless steel
The reason I'm using it because I since I used my carbide tool
It's hard for me to move back because I don't need to resharpen as often as my stainless steel
tool and
Also, I will put a little bit of a chattering mark. So this is my regular stainless steel on number one
so that's the three pieces of the tool I will use and
then for cutting
The spout to fit the body I will use my number seven to a trim
And trim this to fit. So that's number seven
And then after that
After assemble it, of course, I need to have a hole puncher to make
The holes strength for for the tea leaves doesn't come off so a hole puncher and a brush
to brush the slip over
And then using the plastic knife. This is from a fast food store
I get it and then I use the sandpaper just remove the teeth. So this part will be smooth and after I
Assemble the
Spout and the handle I can smooth the corners. Okay, so that's the tool I will use
And first I will trim the body and then I'll try to
Trim the the foot first and then move it
Turn it upside down and then trim a little bit so the lid will fit nicely
In now the lid is a little bit wide
So I will try to fit so they will fit in nicely in here and then trim
The lid right on top of the body and this is my plan. Okay, so I will do the
body trimming first
And then I will use the timeless mode. So you
Don't need to spend a lot of time watching when I'm trimming
So after a detailed trim
The lid and the body they are fitting very tight now
Lid is not moving and I'm ready to assemble the spout
And from here, you can see the spout is a little bit but luckily the can cut
more clay up so
the
This portion here is a bit smaller and also I can trim the spout a little bit shorter
So it should be fine
I always put it behind it and the cast a shadow so I know what where's the curve that I could trim
and at the rubber trimming I
Start to slowly fit it until it's fitting nicely and then I will attach it
And again, I'm going to put it on the fast
Timeless mode so you don't need to spend so much time watching what I'm doing
