Anlyter Propane Stovetop Installation At The Off Grid Cabin

so now that I'm ready um I need to get this laid out marked out so that I can cut the hole in my countertop and get this dropped in all right this uh droping stove comes with a template that you can use to get this in the right position and Trace around so you know where to cut out um so if I take my tape and I measure here I've got inch and 5/8 and I know that the 2x4 that I'm up against is an inch and a half so that's 3 and 1 E inch that's as close to the front as I can go but uh to give myself a little bit of uh fudge room I'll just make that 3 and 1/2 Ines okay so that is where I want to uh place my template so let me go ahead and get that marked out all right I've got my uh my spot marked out so now I guess I got to drill a hole and cut it out hopefully I don't ruin my countertop not sure if you can see or not but this is where I'm cutting this out but to start I need to drill a hole so I'm not going to go right up against the edge because uh I don't want to mess up and go outside so I'll put it about right there [Music] [Applause] [Music] [Music] [Music] [Music] [Music] [Music] all right it uh chipped out pretty bad right here I hope that the overhang covers that oh yeah just covers it so all right I think that's going to be good all right so I've got this set in here and uh looks good fits well it's pretty much in line but uh before I can hook up my gas I need to swap out the nozzles this particular stove supports both Natural Gas and propane but by default it has it uses a uh natural gas nozzle but it did send two extra nozzles which are for propane so what I need to do is swap these two out it also comes with a tool that removes it okay I notice that they're not too tight they're snug but not too tight there's no instructions so no instructions no videos okay that should work now before I set these back on here I need to flip this over and get my uh regulator installed and my hose so the the regulator is going to connect right here and this kit came with some tape but uh I don't know if this is rated for gas or not it's the gas tape that I've seen is yellow so I don't know if this is rated for gas or if it was put in the kit by mistake so so to be on the safe side I'm going to use my own tape I've got the yellow tape which is for gas okay let's see what I've got here okay I've [Music] got I don't think that's going to fit that is not going to fit all right well since this is the wrong hose end right here it doesn't fit into my bottom there I'm going to have to swap this out so I had a another hose custom made so that it would fit so I've got to remove this one place it with the the new one [Applause] [Music] [Applause] [Applause] [Music] all right let's check for leaks okay I'm not seeing any leaks I think we're good to give this a try all right so my front burner Works uh exactly how I would expect it to work the back burner however not quite as good and uh by default these come with uh nozzles for natural gas and I swapped both of those out for the nozzles that are supposed to be for propane so I'm wondering if this one already had a propane nozzle on it and I swapped it for the natural gas one so I'll off camera I'll swap those back and see if that doesn't fix it but uh the uh gas flow on this back one's not quite right but uh I think that's going to do it for this video so we'll talk to you guys later