Tripped breaker, but I’m not finding the short in the system. Where is it?

How many of these do you see that are still functional? That's pretty nice. Gas is on. That's a 2010, so 11 years old. If I'm not mistaken, this is one of those two-stage gas valves. But we're about to find out. That's really tight quarters. So that is a two-stage gas valve. I don't have access to the house just yet, so I'm excited. We got a variable speed blower motor. No power. y'all see that 66 ohms that's not enough to make it beep but that is definitely enough to make it triple breaker here we go and start running or if it's labeled man look at that wire wrapped around the other two 23 mega ohms one mega ohm 670 kilo ohms for here and see see if my 66 ohms nothing i still got 65 ohms all right even though that was showing some kilo ohms to ground there's a good chance it will run i'm not gonna wrap that all the way around if i ain't got to no crankcase heater sometimes these have a little piece that's as big as a big pin that sticks in the bottom of it let me see all right both both poles are broken so i'll test i got 26 ohms to ground now let's see if i got 26 ohms to ground nothing nothing measuring on the top nothing just so close nothing eight ohms five ohms to ground all right yeah that'll trip a breaker if y'all couldn't see what i was doing um i was testing the raw power leads and um not connected to anything they um show to short the ground my problem might be in here i do have a junction right there get right there hard to show what i'm seeing pull this out and uh this right here that's a ground and there's a power wire hey how are you in the hot position let's test the bottom of the breaker my short is on this end towards the air conditioner because of that i'll be honest i'm not seeing anything on this that would make it short the ground nothing we need a new disconnect one on my van that is but it's coming out looks like that just sticks through the wall and i got right there if you've wondered why i carried a hook knife i carry a hook knife it is just for this reason right here hook knife is made for skinning wires look at these that wire can actually slip and get here on the side you need to try to make sure that sets that screw goes right down and pins the wire down on the bottom go in the breaker that's in there to put all that back together i am gonna crack this open and see if i can't see this heat exchanger you know what that may be a stainless heat exchanger we got 240 we can we can now start putting all this back together and turn our heat a little bit tricky took me a little while to find the short i nearly cussed out that fellow on the riding lawn mower but uh thanks for watching i'm on to the next