So verwendet man einen Schrägbandformer

I'll show you now how to use such an oblique tape former. I have a 418 mm here. I'm going to make such oblique strips out of feed, but not with the double one with 36 mm, but that's my professional tip with 40 mm. A little wider than the double of the oblique tape, because by processing the oblique strip becomes a little longer and also narrower and then this measure fits us exactly. So at an angle of 45 degrees, you can piece together this strip in any length you like. You cut it diagonally here, again at an angle of 45 degrees, put it in the opposite direction and sew it together from the outside to here with a width of half a centimeter. Iron out this piece and your oblique strip is twice as long. When you have the right length together, you take the strip, thread it through, pull it out at the front and now another professional tip from me, put this end here, but not up here, but in front, so that you don't pull the iron over the pin with the Teflon sole. And now you pull the oblique tape former slightly further and iron it immediately with the iron. When the whole thing is finished, you fold it in again and you have a beautiful oblique strip. See you at the next professional tip.